COM018

COMSOL: Temperature-dependent elastic material model with creep

Description
This test program is recommended for modeling the creep response of materials with temperature effects.

COMSOL Material
Linear Elastic + Creep

Test Program
We recommend the following base tests:

Test ID

Description

# Temps

# Strain Levels

# Repeats

# Specimens

UT006 - CT/HT

Tensile creep testing (up to 12 hours)

3

2

2

12

Depending on the complexity of loading or deformation, we may recommend the following additional tests:

Test ID

Description

# Temps

# Strain Levels

# Repeats

# Specimens

UC006 - CT/HT

Compression creep testing (up to 12 hours)

3

1

2

6

UT004 - CT/HT

Load/hold tensile test

3

2 (strain levels)

2

12

VC001 - CT/HT

Volumetric compression test

3

1

2

6

VC005 - CT/HT

Volumetric stress relaxation test

3

2 (strain levels)

2

12

Notes

  • Creep testing at 2 or more stress levels is recommended to determine a suitable creep model for this material.
  • Suggested testing at 3 temperatures may be revised depending on the range of temperatures of interest and the material.
  • UC006 may provide non-homogeneous stress/strain data.  Inverse calibration procedures may be necessary.
  • VC001 and VC005 are not needed for an incompressible material.
  • Veryst will provide a calibrated material model for the observed response and the material.
  • The resulting set of parameters can be used directly in COMSOL Multiphysics.


Specimen Requirements for Complete Test Program

  • 30 tensile (dog-bone) specimens
  • 10 planar tension specimens
  • 25 volumetric compression specimens
     

See the description of individual tests for details on specimen geometries.  Note that we request extra specimens to ensure a sufficient supply of specimens for valid testing.

Veryst can also assist in molding standard and non-standard test specimens.  Please contact us if you are interested in discussing this option.

Additional Validation
Veryst can perform additional validation, depending on the target material and the simulation application, through any of the following tests and any necessary component level FE simulation:

  • Impact testing
  • Micro-to-macro indentation responses
  • Compression relaxation tests
  • Cyclic tests with loading/unloading between different strain levels and zero stress level at different rates


More information
For a customized quotation, please write to us at testing@veryst.com and indicate the Test ID (COM018), type of material, test temperatures, specimen geometries available, or other relevant details.

How can we help?